Print

Analysis Features

  •     Overturning safety control for static and dynamic States.
  •     Sliding safety control for static and dynamic states.
  •     Soil bearing capacity control for static and dynamic states.
  •     Global stability safety control for static and dynamic states
  •     Base anchorage calculation
  •     Defining footing key (Optional)
  •     Ground safety stress calculation module
  •     Defining different soil layer behind, front and under the wall
  •     Soil which contains water is behind the wall (Low and High Permeability States)
  •     Taken into account the effect of the groundwater
  •     Considering cohesion and adhesion
  •     Considering angle of friction between wall and soil
  •     Acting uniform load
  •     Checking outside middle third for static and dynamic states
  •     Checking and calculating horizontal acceleration coefficient
  •     Considering eccentricity on checking sliding safety
  •     Different methods can be selected for the calculation of pressure coefficient for active and passive states (Coulomb, Rankine)
  •     Defining different material
  •     Manual seismic coefficient (Ch and Cv) entry
  •     Ignoring the positive effect of surcharge loads (Optional)
  •     Changing the applied point of static and dynamic force.

Contact

Support

Mail List